Siemens SIMATIC ET 200SP HA 장비 매뉴얼 - 페이지 34

{카테고리_이름} Siemens SIMATIC ET 200SP HA에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200SP HA 46 페이지. Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지), 매뉴얼 (50 페이지), 매뉴얼 (34 페이지), 매뉴얼 (38 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (50 페이지), 장비 매뉴얼 (38 페이지), 장비 매뉴얼 (42 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (36 페이지), 장비 매뉴얼 (38 페이지)

페이지 인쇄
Siemens SIMATIC ET 200SP HA 장비 매뉴얼
Technical specifications
Article number
•
•
•
Ambient conditions
Ambient temperature during operation
•
•
•
•
Dimensions
Height
Depth
Derating curve
The following figure shows the load current derating with horizontal and vertical mounting
positions.
3,00
2,50
2,00
1,50
1,00
0,50
0,00
-40
Cycle time
The cycle time describes the time slice in which signals from the inputs are acquired and
processed. The cycle time of the I/O module is 1 ms (250 μs for time stamping).
Minimum pulse length
In order for a pulse or an edge transition to be reliably detected by the I/O module, the signal
status must be active for at least the duration of the minimum pulse length.
In non-redundant mode, the minimum pulse length is greater than the input delay and greater
than the cycle time.
34
between the channels
between the channels and backplane bus
between the channels and the power supply
of the electronics
horizontal installation, min.
horizontal installation, max.
vertical installation, min.
vertical installation, max.
-20
0
20
6DL1131-6BH00-0EH1
No
Yes
No
-40 °C
70 °C
-40 °C
60 °C
115 mm
138 mm
40
60
80
Equipment Manual, 10/2020, A5E39265608-AD
Total current I / A
Horizontal mounting position
Total current I / A
Horizontal mounting position
DI 16x24VDC HA