Epson XP-422 네트워크 매뉴얼 - 페이지 26
{카테고리_이름} Epson XP-422에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson XP-422 35 페이지.
Epson XP-422에 대해서도 마찬가지입니다: 여기에서 시작 (4 페이지)
페이지 인쇄
Network Guide
Connecting to Ethernet
Cannot connect to Ethernet
❏ Is Wi-Fi disabled on the control panel?
If this is set to enabled, you cannot connect to an Ethernet network. Set this to disabled.
❏ Are the hub, Ethernet cable, etc. working properly on an Ethernet network connection?
Verify that the product is turned on, and that the link LED of the product-connected hub port lights/flashes. If the
link LED is off, try the following.
1. Connect to another port.
2. Connect to another hub.
3. Replace the Ethernet cable.
❏ Does the product's communication mode correspond to the hub or router?
Confirm whether the product's communication mode is appropriate for the hub or router.
See the following table to appropriately match up the communication modes of the product and hub/router. (The
product's default communication mode is Auto).
For the procedure on confirming/setting the communication mode of the hub/router, see the user's guide.
For details your product's compatible communication mode, see the user's guide.
Auto
100Base-TX
Full Duplex
100Base-TX
Product
Half Duplex
Settings
10Base-TX
Full Duplex
10Base-TX
Half Duplex
Y: Enable N: Disable
Troubleshooting
Auto
1000
1000
Base-T
Base-T
Full
Half
Duplex
Duplex
Y
Y
Y
N
N
N
Y
N
N
N
N
N
Y
N
N
26
Hub/Router Settings
100
100
Base-TX
Base-TX
Full
Half
Duplex
Duplex
N
Y
Y
N
N
Y
N
N
N
N
10Base
10Base
-TX Full
-TX Half
Duplex
Duplex
N
Y
N
N
N
N
Y
N
N
Y