Siemens SIMATIC NET 설치 매뉴얼 - 페이지 31

{카테고리_이름} Siemens SIMATIC NET에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET 50 페이지. Network components bus terminal
Siemens SIMATIC NET에 대해서도 마찬가지입니다: 사용 설명서 (29 페이지), 사용 설명서 (50 페이지), 사용 설명서 (28 페이지), 조립 지침 매뉴얼 (6 페이지), 제품 정보 (6 페이지), 설치 매뉴얼 (40 페이지), 설치 매뉴얼 (40 페이지), 참조 매뉴얼 (14 페이지), 설치 매뉴얼 (34 페이지), 설치 매뉴얼 (48 페이지), 사용 설명서 (32 페이지)

Device Management

3.2 Configuring the Device

The serial console port implements RS232 DCE (Data Communication Equipment) on

a DB9 connector. The following is the pin-out for the port:

Figure 3.1

Connected internally.

Ethernet Ports

Connect any of the available Ethernet ports on the device to a management

switch and access the RUGGEDCOM RS900F console and Web interfaces via the

device's IP address. The factory default IP address for the RUGGEDCOM RS900F is

https://192.168.0.1.

For more information about available ports, refer to

23)".

3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.

All configuration management is done via the RUGGEDCOM RS900F interface. For

more information about configuring the device, refer to the RUGGEDCOM ROS

Configuration Manual associated with the installed software release.

3.3

The RUGGEDCOM RS900F can be reset (rebooted) using the RESET button. The

RESET button is recessed and can only be reached using a pin or small screwdriver.

To reset the device, quickly press and release the RESET button with a pin.

Serial DB9 Console Port

Name

Reserved (Do Not Connect)

GND

Reserved (Do Not Connect)

"Communication Ports (Page

Installation Manual, 04/2021, C79000-G8976-1350-07

Description

Transmit Data

Receive Data

Signal Ground

RUGGEDCOM RS900F