Siemens SIMATIC NET 설치 매뉴얼 - 페이지 16

{카테고리_이름} Siemens SIMATIC NET에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET 40 페이지. Network components bus terminal
Siemens SIMATIC NET에 대해서도 마찬가지입니다: 사용 설명서 (29 페이지), 사용 설명서 (50 페이지), 사용 설명서 (28 페이지), 조립 지침 매뉴얼 (6 페이지), 제품 정보 (6 페이지), 설치 매뉴얼 (40 페이지), 설치 매뉴얼 (50 페이지), 참조 매뉴얼 (14 페이지), 설치 매뉴얼 (34 페이지), 설치 매뉴얼 (48 페이지), 사용 설명서 (32 페이지)

Forced airflow is not required. However, any increase in airflow will result in a

reduction of ambient temperature and improve the long-term reliability of all

equipment mounted in the rack space.

Note

For detailed dimensions of the device with either DIN rail or panel hardware installed,

refer to

2.3.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RUGGEDCOM RMC30 can be ordered with a DIN rail

adapter preinstalled on the back of the chassis. Use the adapter to mount the device

to a standard 35 mm (1.4 in) IEC/EN 60715 or TS35 DIN rail.

Mounting the Device

To mount the device to a DIN rail, do the following:

RUGGEDCOM RMC30

Installation Manual, 04/2021, C79000-G8976-1008-10

"Dimension Drawings (Page

Hook the top teeth of the adapter onto the DIN rail.

Note

The adapter features a sliding release with a slot at the bottom for a flathead

screwdriver.

DIN Rail

DIN Rail Adapter

Figure 2.1

Mounting the Device to a DIN Rail

Insert a flathead screwdriver into the slot of the sliding release and move it

down.

Push the device against the bottom of the DIN rail, then let go of the sliding

release to latch the device.

2.3.1 Mounting the Device on a DIN Rail

22)".

Installing the Device