Siemens SIMATIC NET APE1404 구성 매뉴얼 - 페이지 20

{카테고리_이름} Siemens SIMATIC NET APE1404에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET APE1404 36 페이지. Application processing engine

Configuring and Using the RUGGEDCOM APE

The following sections describe how to configure and use the RUGGEDCOM APE:

NOTICE

Before using the RUGGEDCOM APE, create a backup image that can be restored

should the module be configured improperly.

Warranty does not support modules rendered inoperable/inaccessible due to config-

uration errors made by the user.

2.1

Use the following default username and password to log in to the RUGGEDCOM APE:

NOTICE

Security hazard – risk of unauthorized access

To prevent unauthorized access to the device, make sure to change the default pass-

word before commissioning the device.

Windows® Embedded Standard

Linux

Linux + CROSSBOW ADM

Check Point GAiA™

2.2

The RUGGEDCOM APE can be used as a firewall, as an external network interface, or

as a one-armed firewall.

As an external network interface, the unprotected network is attached to the

RUGGEDCOM APE external Ethernet port and a firewall application, such as Shore-

wall or Check Point GAiA, is used. The RUGGEDCOM APE firewall acts as the primary

router and forwards traffic to the RX15xx device. This scenario is ideal when Layer 2

device hardware is used.

RUGGEDCOM APE (Application Processing Engine)

Configuration Manual, 12/2019, C79000-G8976-1121-05

Software Platform

Default Username

There is no default username or password for Windows® Embedded

Standard 7 installations. The username and password is set by the

user during the first boot.

root

admin

Default Password

admin