Siemens SIMATIC NET APE1404 구성 매뉴얼 - 페이지 27

{카테고리_이름} Siemens SIMATIC NET APE1404에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET APE1404 36 페이지. Application processing engine

Configuring and Using the RUGGEDCOM APE

2.14 Updating Linux Software

2.14

Updating Linux Software

Outlined below are the steps required when updating the Linux software on the

RUGGEDCOM APE.

Take care to follow the steps below in the correct order. If any steps are omitted or

executed out of order, the RUGGEDCOM APE may become unusable.

NOTICE

To upgrade the complete Linux distribution currently running on the device, contact

Siemens Customer Support.

NOTICE

This procedure is only applicable to Linux variants of the APE1402 and APE1404.

NOTICE

Updates must be performed sequentially. Debian v9 (Stretch) cannot be installed

on a device running Debian v7 (Wheezy). The Linux software on the RUGGEDCOM

APE must be upgraded to Debian 8 (Jessie) before it can be upgraded to Debian v9

(Stretch).

Note

Unless otherwise indicated, Siemens does not provide specific software support for

third-party applications.

Preliminary Steps

Prior to updating the software, do the following:

Restart the module or restart the networking service by typing:

/etc/init.d/networking restart

CAUTION

Make sure the RUGGEDCOM APE is connected to the upgrade server by pinging

the server's name or IP address.

Backup any application or configuration files.

Disable the gma500_gfx driver. Using vi, open the file /etc/mod

probe.d/fbdev-blacklist.conf and add the following line:

blacklist gma500_gfx

When done, save and close the file.

RUGGEDCOM APE (Application Processing Engine)

Configuration Manual, 12/2019, C79000-G8976-1121-05