Siemens SIMATIC NET RUGGEDCOM i801 설치 매뉴얼 - 페이지 18
{카테고리_이름} Siemens SIMATIC NET RUGGEDCOM i801에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC NET RUGGEDCOM i801 38 페이지. Rugged ethernet switches
Siemens SIMATIC NET RUGGEDCOM i801에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지)
페이지 인쇄
2.5
Connecting Power
The RUGGEDCOM i801 supports a single low DC power supply with reverse polarity
and dual independent inputs. This allows for two redundant DC power sources with
the same nominal voltage to be connected.
To connect power to the device, do the following:
•
•
•
•
1.
2.
RUGGEDCOM i801
Installation Manual, 01/2021, C79000-G8976-1003-06
NOTICE
Terminals P1-, P2- and GND are connected together internally. As such, if
redundant power supplies are connected, their negative terminals must be at
the same potential.
Do not field wire the DC power supply on the DC mains or Battery mains.
Use minimum #16 gage wiring when connecting terminal blocks.
Equipment must be installed according to applicable local wiring codes and
standards.
Connect the positive wire from the power source to the positive terminal (P1+ or
P2+) on the terminal block.
2
1
3
Positive Terminal
1
Negative Terminal
2
GND Terminal
3
Chassis Ground Terminal
4
Figure 2.4
Terminal Block Wiring – Single DC Power Supply Input
Connect the negative wire from the power source to the negative terminal (P1-
or P2-) on the terminal block.
Installing the Device
2.5 Connecting Power
4
9