Siemens SIMATIC RTLS4040T 사용 설명서 - 페이지 10
{카테고리_이름} Siemens SIMATIC RTLS4040T에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC RTLS4040T 23 페이지. Localization systems
Siemens SIMATIC RTLS4040T에 대해서도 마찬가지입니다: 사용 설명서 (21 페이지)
페이지 인쇄
Device description
2.3 LED operation display & function button
2.3
LED operation display & function button
The operating states of the transponder are indicated by the LEDs. The states can be off , on
and flashing .
Table 2- 3
LED
Note
Refer to the information in the section "Charging instructions (Page 15)".
Table 2- 4
Display
F1 function key
10
LED status indicator
Meaning
Briefly flashes green once when the F1 function key is pressed and the battery voltage is
sufficient.
Continuously flashes green when the transponder is fully charged and in the charging
station.
Lights up green when the transponder is fully charged and in the charging station.
Briefly flashes red once when the F1 function key is pressed and the battery voltage is low.
Continuously flashes red when the transponder is in the charging station and the battery is
defective.
Remove the transponder from the charging station immediately and do not recharge this
transponder. Contact customer service.
Lights up red if there is an error during charging.
Please also refer to the description of the F1 function key.
Function key
Meaning
When this function key is pressed, 1 message is sent to the Locating Manager
server.
When the F1 function key is pressed, the charge state of the battery is
evaluated and, depending on its voltage, the LED briefly flashes green or red.
In the Locating Manager, you can configure a transponder parameter to
define the threshold value below which the battery voltage is defined as too
low for operation, a "low power" message is generated and the LED flashes
red. Refer to the notes in the section "Operation (Page 15)".
Operating Instructions, 05/2023, C79000-G8976-C596-04
SIMATIC RTLS4040T