Siemens SIMATIC S7-1500R/H 매뉴얼 - 페이지 34
{카테고리_이름} Siemens SIMATIC S7-1500R/H에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-1500R/H 46 페이지. Cpu 1515r-2 pn (6es7515-2rm00-0ab0)
Siemens SIMATIC S7-1500R/H에 대해서도 마찬가지입니다: 매뉴얼 (42 페이지), 장비 매뉴얼 (44 페이지), 매뉴얼 (45 페이지), 장비 매뉴얼 (44 페이지)
페이지 인쇄
Note
MAINT LED of the two CPUs
The MAINT LEDs of both CPUs only go out when the following conditions are fulfilled:
• The CPUs are in the RUN-Redundant system state.
• No maintenance is demanded.
Note
LED displays in redundant operating state
In the RUN-Redundant system state, the LED displays on both CPUs are identical
(exception: you are performing an LED flash test on one CPU).
Meaning of LINK RX/TX LED
Each port of the X1, X2, X3 and X4 interfaces has a LINK RX/TX LED. The table below
shows the various LED patterns of the ports of the CPU 1517H-3 PN.
Table 4- 2
Meaning of LINK RX/TX LED
LINK TX/RX LED
Off
Flashes green
Illuminated green
LED flashes
yellow/green
CPU 1517H-3 PN (6ES7517-3HP00-0AB0)
Equipment Manual, 11/2019, A5E42011886-AB
There is no connection between the interface of the device and a communication partner.
No data is currently being sent/received via the interface.
There is no LINK connection.
The redundancy connections were interrupted.
The CPU performs an LED flash test.
There is a connection between the interface of the device and a communication partner.
The redundancy connections are OK.
Data is currently being received or sent by a communication partner via the interface of the
device.
Interrupts, diagnostics, error messages and system events
4.1 Status and error display of the CPU
Meaning
33