Siemens SIMATIC S7-200 매뉴얼 - 페이지 5

{카테고리_이름} Siemens SIMATIC S7-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-200 30 페이지. Ethernet gateway for simatic mpi/ profibus driver
Siemens SIMATIC S7-200에 대해서도 마찬가지입니다: 매뉴얼 (35 페이지), 드라이버 매뉴얼 (28 페이지), 매뉴얼 (49 페이지), 매뉴얼 (18 페이지), 시스템 매뉴얼 (20 페이지)

페이지 인쇄

Prerequisites, installation, and overview

Prerequisites

The following software must be installed on your computer or programming device:

● SIMATIC STEP 7-Micro/WIN V4.0 SP6 (or later)

● SIMATIC STEP 7 Basic V10.5 SP2

● SIMATIC S7-200 to SIMATIC S7-1200 software conversion tool

The STEP 7-Micro/WIN program that you want to convert must have these properties:

● The program must have been created using STEP 7-Micro/WIN V4.0 SP7 or an earlier

● The program must have been created using SIMATIC programming mode. IEC

● The program must have been saved in LAD (ladder editor) format.

● The program must compile with no errors.

● All user-defined password block protection must have been removed from the

Install the converter software

● STEP 7 Basic V10.5 SP2 and STEP 7-Micro/WIN V4.0 SP7 (or later) must already be

● Double-click the setup.exe file that installs the SIMATIC S7-200 to SIMATIC S7-1200

SIMATIC S7-200 to SIMATIC S7-1200 software conversion tool

Manual, 1/2010

version of STEP 7-Micro/WIN.

programming mode is not supported.

STEP 7-Micro/WIN program. Remove the password protection from the main routine,

subroutines, interrupt routines, and all data pages in the data block. Any program block

that is password protected will not be converted.

Note

If a STEP 7-Micro/Win wizard has generated and protected program blocks, then the

block protection cannot be removed and these program blocks are not converted.

installed or your computer or programming device.

software conversion tool. You can run the setup.exe file from any directory.