Siemens SINAMICS G120 시작하기 - 페이지 6

{카테고리_이름} Siemens SINAMICS G120에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINAMICS G120 50 페이지. Using blocksize converters in marine applications
Siemens SINAMICS G120에 대해서도 마찬가지입니다: 시작하기 (46 페이지), 사용 설명서 (32 페이지), 시작하기 (30 페이지), 하드웨어 설치 지침 (2 페이지), 설치 지침 및 사용 설명서 (2 페이지), 설치 지침 (2 페이지), 설치 지침 (2 페이지), 간결한 사용 설명서 (32 페이지), 매뉴얼 (42 페이지), 장치 설명서 (34 페이지), 빠른 설치 매뉴얼 (2 페이지), 애플리케이션 설명 (50 페이지), 간결한 사용 설명서 (2 페이지), 매뉴얼 (31 페이지), 애플리케이션 매뉴얼 (34 페이지), 간결한 사용 설명서 (2 페이지), 간결한 사용 설명서 (2 페이지)

Table of contents

Objective of these instructions

This Getting Started describes how you install an inverter and commission and operate it

using the IOP operator panel.

The functions and properties of the IOP are described in detail in the "SINAMICS IOP"

operating instructions and are only explained here to an extent that is necessary to

understand the described functions.

Additional information on SINAMICS G120

All manuals for the inverter can be downloaded from the Internet and are additionally

available on DVD. See also Section: Manuals and technical support (Page 47).

What is the meaning of the symbols in the manual?

Firmware upgrade and downgrade

Options for upgrading and downgrading the firmware can be found on the Internet at

http://support.automation.siemens.com/WW/view/de/67364620

(http://support.automation.siemens.com/WW/news/en/67364620).

Transferring license terms of the OSS code to a PC

Procedure

To transfer the OSS license terms from the inverter to a PC, proceed as follows:

1. Switch off the inverter power supply.

2. Insert an empty memory card into the card slot of the inverter. Also see Section:Installing

Control Unit (Page 20)

3. Switch on the inverter power supply.

4. When you have switched on the power supply, wait 30 seconds.

During this time, the inverter writes the "Read_OSS.ZIP" file onto the memory card.

5. Switch off the inverter power supply.

6. Remove the card from the inverter.

7. Use a card reader and load the file to a PC.

You have then transferred the OSS license terms from the inverter to a PC.

An operating instruction starts here.

This concludes the operating instruction.

Converter with Control Units CU230P-2; CU240B-2; CU240E-2

Getting Started, 04/2014, A5E32885834B AB