Siemens SINAMICS G120P 사용 설명서 - 페이지 11

{카테고리_이름} Siemens SINAMICS G120P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINAMICS G120P 26 페이지. Line reactors for power modules pm330
Siemens SINAMICS G120P에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 사용 설명서 (26 페이지), 사용 설명서 (34 페이지), 사용 설명서 (24 페이지), 사용 설명서 (22 페이지), 사용 설명서 (22 페이지), 사용 설명서 (22 페이지), 매뉴얼 (18 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

General

Description

The du/dt filter plus voltage peak limiter comprises two components: the du/dt reactor and

the Voltage Peak Limiter, which cuts off the voltage peaks and returns the energy to the DC

link.

The du/dt filters plus Voltage Peak Limiter must be used for motors for which the proof

voltage of the insulation system is unknown or insufficient.

du/dt filters plus Voltage Peak Limiters limit the rate of voltage rise to values < 500 V/µs and

the typical voltage peaks with rated line voltages to < 1000 V at U

Assignment of du/dt filter plus Voltage Peak Limiter and Power Module

Table 2- 1

Assignment of du/dt filter plus Voltage Peak Limiter and Power Module

Power Module

6SL3310-1PE33-0AA0

6SL3310-1PE33-7AA0

NOTICE

Maintain ventilation clearances

The 100 mm clearances above and below the components must be observed.

NOTICE

Do not interchange the I/Os

The terminals on the voltage limiting network (Voltage Peak Limiter) must always be

connected as follows:

• Cable from the DC link of the Power Module at DCP, DCN and

• Cable to the du/dt reactor 1U2, 1V2, 1W2.

Failure to connect the terminals correctly could damage the voltage peak limiter.

dV/dt filter plus Voltage Peak Limiter

Operating Instructions, 11/2013, A5E32847105B AA

Rated power of the Power Module

Line voltage 380 – 480 V 3 AC

160 kW

200 kW

< 575 V

line

Matching du/dt filter plus Voltage Peak

Limiter

6SL3000-2DE35-0AA0