Siemens SINAMICS G120P 사용 설명서 - 페이지 15

{카테고리_이름} Siemens SINAMICS G120P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINAMICS G120P 22 페이지. Line reactors for power modules pm330
Siemens SINAMICS G120P에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 사용 설명서 (26 페이지), 사용 설명서 (34 페이지), 사용 설명서 (24 페이지), 사용 설명서 (22 페이지), 사용 설명서 (26 페이지), 사용 설명서 (22 페이지), 매뉴얼 (18 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

Mechanical installation

When the line filter is installed in a cabinet, it must be positioned directly beside the Power

Module.

The line reactor must be positioned between the line filter and Power Module. Cabling must

be kept as short as possible.

To prevent interference being injected into the interference-suppressed line cable (this can,

in some cases, nullify the effects of the line filter), the line cable to the line filter must be

routed separately from other cables.

The housing of the Power Module and line filter must be connected with low resistance for

high-frequency interference currents. This can be achieved by installing the Power Module

and line filter on the same mounting plate. The Power Module and line filter must be

connected to the mounting plate with the greatest possible surface area. The best solution

here is to use a metallic, bare, oil-free mounting plate (e.g., made of stainless steel or

galvanized sheet-steel) because the entire contact surface establishes the electrical contact.

If a painted mounting plate is used, the screw positions for the Power Module and line filter

must free of paint to ensure electrical contact with the mounting plate.

The motor must always be connected using a shielded cable. The shield must be applied to

the motor and Power Module with the greatest possible surface area.

The ground wire for the motor must be fed directly back to the Power Module.

Line filter

Operating Instructions, 11/2013, A5E32844996B AA