Epson XP-600 빠른 매뉴얼 - 페이지 33

{카테고리_이름} Epson XP-600에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson XP-600 40 페이지. Xp-600 impresora small-in-one
Epson XP-600에 대해서도 마찬가지입니다: 시작 매뉴얼 (4 페이지), 매뉴얼 (46 페이지), 여기에서 시작 (4 페이지), 제품 사양 (2 페이지), 기본 매뉴얼 (24 페이지), (설치 가이드 (4 페이지)

Epson XP-600 빠른 매뉴얼
Allow space behind the product for the cables, and space above the product so that you can
fully raise the document cover.
Leave enough space in front of the product for the paper to be fully ejected.
Leave enough room around the product for sufficient ventilation. Make sure the product is at
least 4 inches (10 cm) away from the wall.
Do not block or cover openings in the product case or insert objects through the slots.
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
Do not press too hard on the scanner glass when placing the originals.
Do not open the scanner section while the product is copying, printing, or scanning.
Be careful not to trap your fingers when closing the scanner cover or scanner.
Do not touch the flat white cable inside the product.
Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
Adjust only those controls that are covered by the operating instructions. Except as specifically
explained in your documentation, do not attempt to service the product yourself.
Never disassemble, modify, or attempt to repair the product by yourself, except as specifically
explained in the documentation. Do not adjust controls that are not covered by the operating
instructions.
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
Always keep this guide handy.
Touch Panel Safety
Press the touch panel gently with your fingertip. Do not press with force or use your fingernail.
The LCD screen may contain a few small bright or dark spots or uneven brightness. This is
normal and does not indicate that the touch panel is damaged in any way.
Use only a dry, soft cloth to clean the touch panel. Do not use liquid or chemical cleansers.
Do not use items such as ball point pens, pencils, etc. to operate the touch panel.
Do not touch the panel with wet or gloved hands or through the protective sheet or sticker; it
may not respond.
Do not place heavy items on the touch panel. Contact Epson if the panel chips or cracks; do
not attempt to remove broken pieces.
Do not place your product in areas where abrupt changes in temperature or humidity may
occur. Condensation inside the panel may cause performance to deteriorate.
33
Notices