Siemens SINAMICS S120 매뉴얼 - 페이지 3

{카테고리_이름} Siemens SINAMICS S120에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINAMICS S120 41 페이지. Applications for cabinet modules, liquid-cooled
Siemens SINAMICS S120에 대해서도 마찬가지입니다: 운영 매뉴얼 (20 페이지), 시작하기 (32 페이지), 짧은 설명 (22 페이지), 매뉴얼 (43 페이지), 해양 드라이브 애플리케이션용 캐비닛 설치 지침 (28 페이지), 애플리케이션 매뉴얼 (34 페이지), 애플리케이션 매뉴얼 (46 페이지), 사용 설명서 (22 페이지), 시작하기 (32 페이지), 사용 설명서 (21 페이지), 엔지니어링 매뉴얼 (30 페이지), 시운전 매뉴얼 (20 페이지)

1 Task

Task

1.1

1.1.1

Industrial Ethernet communication networks continue to gain global importance in

automation solutions. Industrial Ethernet connectivity down to device level

components (i.e. drives, I/O, etc.) is an end user requirement that demands

openness and flexibility. To capitalize on the flexibility to connect to different

Industrial Ethernet protocols the SINAMICS S120 drives can seamlessly be applied

in PROFINET and EtherNet/IP networks.

1.1.2

Since Firmware version 5.1SP1 both the CU310-2 PN and Cu320-2 PN can be

commissioned for EIP via on board Ethernet ports. The CBE20 is no longer

necessary for EIP communication and the onboard X150 ports are utilized for EIP

communication.

The network IP address of the S120 CU (Control Unit) is set through the STARTER

or STARTDRIVE software. With STARTER software installed on your computer

you can connect to the SINAMICS drive through the built in X150 ports on

CU310-2 or CU320-2 and set IP address.

The SINAMICS S120 multi-axis drive system can contain up to six vector or servo

axis controlled by a single CU320-2 control unit. This allows one IP address for the

CU320-2 to control multiple drive objects thus cutting down on the number of IP

addresses and Ethernet connections required for drive systems. For the CU310-2

it is a single drive axis but can have additional control and status for the Control

Unit if needed.

The SINAMICS drives operate on unicast telegrams thus further reducing network

traffic. SINAMICS S120 drives have been certified by ODVA for EtherNet/IP

conformance testing and participated in the EtherNet/IP PlugFest. Siemens is a

member of ODVA with Vendor ID # 1251.

SINAMICS S: Speed control of a S120 with an Allen-Bradley controller

(Compact/ ControlLogix with RSLogix 5000) via EtherNet/IP

Entry-ID: 92045369,

V4.0,

08/2018