Siemens SINUMERIK 장비 매뉴얼 - 페이지 6
{카테고리_이름} Siemens SINUMERIK에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 24 페이지. Emergency stop button
Siemens SINUMERIK에 대해서도 마찬가지입니다: 장비 매뉴얼 (28 페이지), 장비 매뉴얼 (26 페이지), 장비 매뉴얼 (26 페이지), 장비 매뉴얼 (26 페이지), 장비 매뉴얼 (28 페이지)
페이지 인쇄
Fundamental safety instructions
1.1 General safety instructions
Electric shock due to equipment damage
Improper handling may cause damage to equipment. For damaged devices, hazardous
voltages can be present at the enclosure or at exposed components; if touched, this can result
in death or severe injury.
• Ensure compliance with the limit values specified in the technical data during transport,
• Do not use any damaged devices.
Electric shock due to unconnected cable shields
Hazardous touch voltages can occur through capacitive cross-coupling due to unconnected
cable shields.
• As a minimum, connect cable shields and the cores of cables that are not used at one end
Electric shock if there is no ground connection
For missing or incorrectly implemented protective conductor connection for devices with
protection class I, high voltages can be present at open, exposed parts, which when touched,
can result in death or severe injury.
• Ground the device in compliance with the applicable regulations.
NOTICE
Damage to equipment due to unsuitable tightening tools.
Unsuitable tightening tools or fastening methods can damage the screws of the equipment.
• Be sure to only use screwdrivers which exactly match the heads of the screws.
• Tighten the screws with the torque specified in the technical documentation.
• Use a torque wrench or a mechanical precision nut runner with a dynamic torque sensor and
6
WARNING
storage and operation.
WARNING
at the grounded housing potential.
WARNING
speed limitation system.
ONE MCP Part 2: MCP 1900
Equipment Manual, 07/2020, A5E50324718B AA