Siemens SIREMOBIL Iso-C 서비스 지침 매뉴얼 - 페이지 12
{카테고리_이름} Siemens SIREMOBIL Iso-C에 대한 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIREMOBIL Iso-C 16 페이지.
Siemens SIREMOBIL Iso-C에 대해서도 마찬가지입니다: 설치 및 설정 지침 (4 페이지), 설치 및 설정 지침 매뉴얼 (6 페이지), 유지 관리 지침 (46 페이지), 설치 지침 매뉴얼 (6 페이지)
페이지 인쇄
12
1
Fig. 23
Fig. 25
•
Reinstall the end stop (Fig. 23). Do not insert any screws in the threaded hole (1/Fig. 23)
(This is the threaded hole for the MODULARIS docking plate)
•
Remount the complete angulation brake and attach it with the screws (Fig. 24).
•
Connect plugs X22/X23.
•
Remount the horizontal guide bearings for the horizontal carriage. (1/Fig.25)
•
The center guide bearing (2/Fig.25)is equipped with an eccentric bolt.
•
Switch ON the SIREMOBIL and release the horizontal lift brake.
•
Move the vertical lift until the C-arm is no longer on the work table.
•
Move the horizontal carriage slowly from end stop to end stop. When doing this, the
horizontal carriage should be centered on the shaft and should not drag at any point
(Fig. 26 indicates the schematic top view of the horizontal carriage).You may have to
adjust the eccentric bolt (2/Fig. 25).
SIREMOBIL Iso-C
Replacing the horizontal lift brake
1
2
Fig. 24
Fig. 26
SPR2-230.076.01
Rev. 01
02/99
Page 12 of 16
TD SD 24
Medical Engineering
Siemens AG