Siemens SIREMOBIL Iso-C 유지 관리 지침 - 페이지 30
{카테고리_이름} Siemens SIREMOBIL Iso-C에 대한 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIREMOBIL Iso-C 46 페이지.
Siemens SIREMOBIL Iso-C에 대해서도 마찬가지입니다: 설치 및 설정 지침 (4 페이지), 서비스 지침 매뉴얼 (16 페이지), 설치 및 설정 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (6 페이지)
페이지 인쇄
30
3.1.1
I.I. laser light localizer
SIM
Mechanical system
•
Inspect the I.I. laser light localizer for mechanical damage.
•
Mount the I.I. laser light localizer on the I.I. and ensure proper locking and seating.
When doing this, pay special attention to the tension band and its closure.
•
Check the I.I. ring for damage.
SIM
Function
•
Perform maintenance on the I.I. laser light localizer according to Installation and Set-
ting Instructions RXR2-130.033.03...
3.1.2
Laser light localizer
SIM
Mechanical system
•
Inspect the I.I. cap of the laser light localizer for mechanical damage.
•
Install the I.I. cap of the laser light localizer on the I.I. and ensure proper locking and
seating.
•
Check the I.I. ring for damage.
SIM
Function
•
Perform the maintenance steps specified according to the adjustment instructions
SPR2-230.032.01..
3.1.3
DICOM bridge
SIM
Mounting
•
Check the mounting of the DICOM bridge in the monitor trolley.
3.1.4
Codonics printer
SIM
Mounting
•
Inspect the screws used to fasten guide rail to the mounting bracket of the Framegrab-
ber.
•
Ensure that the printer is properly fastened to the guide rail. Make sure there are no
missing attachment screws.
•
Ensure that the Framegrabber is properly fastened to the mounting bracket. Make sure
there are no missing attachment screws.
SIM
Guide rails
•
Inspect the guide rails for proper function and smooth operation.
•
The guide rails must not be damaged.
•
The guide rails must lock properly into place when fully pushed into position.
•
If necessary, use a cleaning brush to remove dirt from the rails.
SIREMOBIL Iso-C
SPR2-230.101.02.06.02
07.05
Safety Inspection
Page 30 of 46
CS PS 24
Siemens AG
Medical Solutions