Siemens SIRIUS Soft Starter 3RW5 PCS 7 Library 시작하기 - 페이지 13

{카테고리_이름} Siemens SIRIUS Soft Starter 3RW5 PCS 7 Library에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIRIUS Soft Starter 3RW5 PCS 7 Library 36 페이지. Industrial controls

페이지 인쇄

Introduction

4.1

Introduction

This document was created under the usage of Soft Starter 3RW5 PCS 7 Library V9.0 SP2

and explains the basic principles of using this library. The Soft Starter 3RW5 PCS7 Library is

designed according to APL standards for both, blocks and faceplates. This library contains

two CFC templates to fulfill the configurations for 3RW52 and 3RW55 devices.

For reducing configuration time, module driver generation is supported by the library. By

using this driver generator it is ensured that all necessary interconnections will be handled

automatically and the device is ready to operate in SIMATIC PCS 7 environment.

Custom configuration can be done by the user as well. User manual and online help will give

detailed information about the blocks and their input and output pins.

This document will guide you through the necessary steps for using the template and the

module driver generator in a SIMATIC PCS 7 environment using a sample project. This

sample project uses minimum hardware, single station, PLC connected to one 3RW52 Soft

Starter via PROFINET and one 3RW55 Soft Starter via PROFIBUS.

Prerequisites

User

SIMATIC PCS 7 knowledge:

● Project creation

● HW-Config

● CFC-Editor

● WinCC-Explorer

Refer reference (Page 33) section for the link to "Process Control System PCS 7 Getting

Started" for further details and to find the manuals for your SIMATIC PCS 7 Version in the

manual collection.

System

● Installed and compatible SIMATIC PCS 7 version

● Installed Soft Starter 3RW5 PCS7 Library V9.0 SP2

● SIMATIC PCS 7 Multiproject (created by Project-Wizard).

SIRIUS Soft Starter 3RW5 PCS 7 Library

Getting Started, 02/2020, A5E48411356002A/RS-AA/001