Siemens SITRANS WW300 사용 설명서 - 페이지 21

{카테고리_이름} Siemens SITRANS WW300에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS WW300 42 페이지. Weighfeeders
Siemens SITRANS WW300에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지)

페이지 인쇄

Commissioning

Your weighfeeder has been factory run-in for a minimum of four hours; it should require little

adjustment. However, periodic inspections of the belt tracking are recommended.

Start the belt and observe rotation.

Turn off and lock out all power sources before correcting rotation. On AC motors, reverse 2

of the 3 motor wires.

Start the belt again, and observe the machine as it is running. If the belt is not tracking correctly,

or is travelling off center, see Belt tracking (Page 21).

7.1

Shear gate

The shear gate on the inlet of the weighfeeder needs to be set to allow the maximum feed rate

capacity required. Consult your Siemens representative if feed rate changes are required.

7.2

Skirtboards

The skirtboards have been factory set to proper specifications. Note that near the inlet, the

skirtboards are very close to the belt. However, toward the discharge end of the weighfeeder,

the skirtboards are 3 to 5 mm (1/8 to 3/16") higher off the belt. This relieving effect minimizes the

possibility of material becoming lodged between the skirtboard and the belt.

Periodic adjustments of the skirtboards should not be necessary but if adjustment is required,

set the skirtboards at the heights described above.

SITRANS WW300

Operating Instructions, 05/2015, A5E33560691-AB

WARNING