Siemens SITRANS WW300 사용 설명서 - 페이지 17

{카테고리_이름} Siemens SITRANS WW300에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS WW300 28 페이지. Weighfeeders
Siemens SITRANS WW300에 대해서도 마찬가지입니다: 사용 설명서 (42 페이지)

페이지 인쇄
Siemens SITRANS WW300 사용 설명서
• frame is not warped or twisted
• head and tail pulley are parallel to each other
• plow is contacting underside
2.
Turn on the feeder and observe its tracking line on the head and tail pulleys.
If the belt is drifting toward one side of the feeder, then adjust the telescoper on
either side of the machine (see below).
3.
Do not adjust belt tracking rollers, they have been factory set.

Telescoper Adjustment

1.
Determine which side of the weighfeeder you want to adjust. Compressing the
telescoper on one side will cause the belt to drift toward that side of the
weighfeeder. Conversely, extending the telescoper will cause the belt to drift away
from that side of the weighfeeder.
2.
Loosen the jam nut.
3.
Turn the adjusting screw in the desired direction. Often, only a small adjustment (1
turn or less) is required.
4.
Observe the results of the adjustment and then readjust, if necessary.
As you extend or compress the telescoper, you may be changing the belt
Note:
tension. If belt tension has increased (or decreased) considerably while attempting to
track the belt, then compress (or extend) both telescopers and complete the belt
tracking process again. To avoid this problem, extend one telescoper while
compressing the other to obtain proper belt tracking.
5.
Re-tighten the jam nut located on the telescoper to maintain the new telescoper
position after completing the tracking procedure.
6.
If you are having problems tracking the belt, consult your Siemens representative.
Common causes of belt tracking problems are: uneven or improperly distributed
product loading, twisted frame, or product build-up on head or tail pulleys.
adjusting screw
7ML19985MQ01
SITRANS WW300 - OPERATING INSTRUCTIONS
jam nut
driven shaft
Page 13