Siemens 125-1957 소유자 매뉴얼 - 페이지 32

{카테고리_이름} Siemens 125-1957에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens 125-1957 48 페이지. Apogee unit vent controller ⎯ 0 to 10v output

APOGEE Unit Vent Controller

Application 2299 – Slave Mode

Application 2299 is the slave mode application for the Unit Vent Controller—0 - 10V Output

(P/N 540-509). Slave mode is the default application that comes up when power is first

applied to the controller. Slave mode provides no control. Its purpose is to allow the operator

to perform equipment checkout before a control application is put into effect and to set some

basic controller parameters (CTLR ADDRESS, APPLICATION, etc.).

NOTE:

The input labeled "DI3/AI3" on the controller can be used either as a DI point or as an Analog

Input (AI) point, but not both at the same time.

⎯

0 to 10 V Output Owner's Manual

Slave mode provides no control.

Siemens Building Technologies. Inc.