Siemens 353 사용자 설명서
{카테고리_이름} Siemens 353에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens 353 4 페이지. Multi-purpose training panel
Siemens 353에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)
Siemens
Energy & Automation
Model 353 Process Automation Controller
INVOLVED MANUALS
User's Manual, Model 353 Process Automation Controller, UM353-1, Rev. 8 and earlier.
DISCUSSION
Direct entry rear connectors will begin shipping in March 2001. Direct entry connectors are described in
this Addendum and all power, ground, station common, and signal terminals are identified.
Consult the nameplate on the case to determine whether direct entry connectors have been installed.
Model 353_2_ _ _ _ _ _ _ _ _ _ Side entry
Model 353_4_ _ _ _ _ _ _ _ _ _ Direct entry connectors with Ethernet connector are installed
Section 6 Installation, in UM353-1, describes the black side
entry connectors and the connections to be made to them. In
the following, the direct entry connectors will be described
and illustrated.
Direct entry connectors are shown in the adjacent figure.
There are four connectors with 52 screw-clamping terminal
connections. Each connector consists of a case mounted
portion and a plug-in portion. The plug-in portion of each
connector is securely fastened to the case mounted portion
by a screw at each end of the plug-in. The plug-in portion
can be completely wired and then plugged into the case
mounted portion.
Terminal functions and numbers have not changed. For
example, Station/Transmitter Common is terminal 6 on the
side entry and direct entry connectors.
A standard 8-wire Ethernet connector is provided near the
bottom of the assembly. A case ground screw is provided
near the top of the assembly, as in the side entry connectors.
The next page contains an illustration that states the
connections to the direct entry connectors.
1
Side entry and direct entry refer to the entry of wires into terminals installed on a rear connector assembly.
USER'S MANUAL ADDENDUM
1
Direct Entry
Rear Connectors
1
connectors are installed
UMA353-1-6
Rev. 1
April 2001