Cisco WS-X45-SUP6L-E 설치 및 구성 참고 사항 - 페이지 11
{카테고리_이름} Cisco WS-X45-SUP6L-E에 대한 설치 및 구성 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X45-SUP6L-E 28 페이지.
페이지 인쇄Figure 2
By default, the Ethernet management port is enabled. The switch cannot route packets from the Ethernet
management port to a network port, and from the network port to the Ethernet port. To obtain these, the
Fa1 interface is automatically placed in a separate routing domain (or VRF domain), called mgmtVrf.
(You observe the ip Vrf forwarding mgmtVrf line in the running configuration when you boot up.)
Even though the Ethernet management port does not support routing, you might need to enable routing
protocols on the port. As illustrated in
management port when the PC is multiple hops away from the switch and the packets must pass through
multiple Layer 3 devices to reach the PC.
Figure 3
The specific implementation of Ethernet management port depends on the redundancy model you are
applying.
OL-19334-02
Connecting a Switch to a PC
Ethernet
management
Switch
port
Network
ports
Network
cloud
Network Example with Routing Protocols Enabled
Ethernet
management
Switch
port
Network
ports
Network
cloud
Installation and Configuration Note for the Cisco Catalyst 4500 E-Series Supervisor Engine 6L-E
Figure
3, you must enable routing protocols on the Ethernet
Network
cloud
Supervisor Engine 6L-E
PC
PC
11