Cisco WS-X5161 매뉴얼 - 페이지 18

{카테고리_이름} Cisco WS-X5161에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X5161 33 페이지. Configuring token ring lan emulation
Cisco WS-X5161에 대해서도 마찬가지입니다: 제품 지원 게시판 (6 페이지)

페이지 인쇄

Setting Up the LES BUS for an ELAN

Command or Action

Step 4 ATM(config-if)# exit

Step 5 ATM# copy running-config startup-config

Setting Up a LES BUS and a LEC

For each Catalyst 5000 series switch ATM module that will participate in LANE, set up the necessary

servers and clients for each ELAN and then display and record the server and client ATM addresses. Be

sure to keep track of the switch ATM interface where the LECS will eventually be located.

If you will have only one default ELAN, you only need to set up one server. If you will have multiple

ELANs, you can set up the server for another ELAN on a different subinterface on the same interface of

this switch, or you can place it on a different switch.

When you set up a server and BUS on a switch, you can combine them with a client on the same

subinterface, a client on a different subinterface, or no client at all on the switch.

Depending on where your clients and servers are located, perform one of the following tasks for each

LANE subinterface:

•

Setting Up the LES BUS for an ELAN

To set up the LES/BUS for an ELAN, use the following commands beginning in global configuration

mode.

SUMMARY STEPS

1. ATM(config)# interface atmnumber [.subinterface-number ]

2. ATM(config-if)# lane server-bus tokenringelan-name1

3. Repeat Steps 1 and 2 for all LES/BUSs you want to configure on the ATM module.

4. ATM(config-if)# exit

5. ATM# copy running-config startup-config

DETAILED STEPS

Command or Action

Step 1 ATM(config)# interface atmnumber [.subinterface-

number ]

Step 2 ATM(config-if)# lane server-bus tokenringelan-name1

Setting Up the LES BUS for an ELAN, page 18

Setting Up a LEC for an ELAN, page 19

Guidelines for Setting Up a LEC, page 19

Creating a Token Ring VLAN, page 21

Setting Up the Token Ring VLAN on a LEC, page 22

Purpose

Exits interface configuration mode.

Saves the configuration.

Purpose

Specifies the subinterface for the first ELAN on this switch

and enters interface configuration mode.

Enables a LES/BUS for the first ELAN on the subinterface

(you cannot configure more than one LES/BUS per

subinterface).

Setting Up a LES BUS and a LEC