Cisco WS-X5162 매뉴얼 - 페이지 33

{카테고리_이름} Cisco WS-X5162에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X5162 33 페이지. Configuring token ring lan emulation
Cisco WS-X5162에 대해서도 마찬가지입니다: 제품 지원 게시판 (6 페이지)

페이지 인쇄

Configuring the LES BUS and the LEC Example

The commands shown in this step start the LECS. The database to use is test. The interface on which the LECS is

configured is atm0.

Step 11

Save the configuration in NVRAM by entering the write memory command, as follows:

Example:

ATM# write memory

Step 12

Start the LEC on the Catalyst 5000 series switches 1 and 2 by entering the interface atm0.1 command and the lane

client tokenring 112 crf112 interface configuration command in configuration mode on the consoles of switches 1 and

2. The interface on which the LEC is configured is atm0.1. The ELAN name is default, and it is configured to emulate

Token Ring. You see the following display:

Example:

ATM# configure terminal

Enter configuration commands, one per line.

ATM(config)# interface atm0.1

ATM(config-subif)# lane client tokenring 112 crf112

ATM(config-subif)# end

ATM#

Step 13

Save the configuration in NVRAM by entering the write memory command, as follows:

Example:

ATM# write memory

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S.

and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks.

Third-party trademarks mentioned are the property of their respective owners. The use of the word partner

does not imply a partnership relationship between Cisco and any other company. (1110R)

Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be

actual addresses and phone numbers. Any examples, command display output, network topology diagrams,

and other figures included in the document are shown for illustrative purposes only. Any use of actual IP

addresses or phone numbers in illustrative content is unintentional and coincidental.

End with CNTL/Z.