Cisco WS-X6066-SLB-APC - Content Switching Module 설치 참고 사항 - 페이지 20
{카테고리_이름} Cisco WS-X6066-SLB-APC - Content Switching Module에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-X6066-SLB-APC - Content Switching Module 28 페이지. Catalyst 6500 series switch content switching module
페이지 인쇄
Verifying the Installation
Figure 7
FAN
STATUS
e.
This completes the CSM installation procedure.
Verifying the Installation
When you install the CSM in a Catalyst 6500 series switch, the module goes through a startup sequence
that requires no intervention. At the successful conclusion of the startup sequence, the green Status LED
will light and remain on. If the Status LED does not show green, or if it shows a different color, refer to
Table 1 on page 8
Using the CLI
The software interface for the module is the Cisco IOS and the Catalyst operating system command-line
interface accessed through a Telnet connection to the switch or through the switch console interface.
Refer to the Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide and the Catalyst 6500
Series Switch Software Configuration Guide for details.
Catalyst 6500 Series Switch Content Switching Module Installation Note
20
Ejector Lever Closure in a Vertical Slot Chassis
All ejector levers flush
with module faceplate
Tighten the two captive installation screws on the module.
Note
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
to determine the modules status.
78-15751-03