Samsung 192T - SyncMaster 192 T 사용자 설명서 - 페이지 19

{카테고리_이름} Samsung 192T - SyncMaster 192 T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung 192T - SyncMaster 192 T 49 페이지. Tft-lcd monitor
Samsung 192T - SyncMaster 192 T에 대해서도 마찬가지입니다: 서비스 매뉴얼 (44 페이지)

페이지 인쇄

Before calling for service, check the information in this section to see if you can remedy any

problems yourself. If you do need assistance, please call the phone number on the warranty card,

the phone number on the Information section or contact your dealer.

Check List

Symptom

No images on the screen.

I cannot turn on the monitor.

Troubleshooting

Check List

Is the power cord connected

properly?

Can you see "No Connection,

Check Signal Cable" on the screen?

If the power is on, reboot the

computer to see the initial screen

(the login screen), which can be

seen.

Can you see "Video mode not

supported" on the screen?

There is no image on the screen.

Is the power indicator on the

monitor blinking at 1 second

intervals?

Connected using the DVI cable?

Solution

Check the power cord connection

and supply.

(Connected using the D-sub cable)

Check the signal cable connection.

(Connected using the DVI cable)

If you still see an (error) message

on the screen when the monitor is

connected properly, check to see if

the monitor status is set to

analogue. Press Source button to

have the monitor double-check the

input signal source.

If the initial screen (the login screen)

appears, boot the computer in the

applicable mode (the safe mode for

Windows ME/2000/XP) and then

change the frequency of the video card.

(Refer to the Preset Display Modes)

Note: If the initial screen (the login

screen) does not appear, contact a

service center or your dealer.

You can see this message when the

signal from the video card exceeds the

maximum resolution and frequency

that the monitor can properly handle.

Adjust the maximum resolution and

frequency that the monitor can

properly handle.

The monitor is in PowerSaver mode.

Press a key on the keyboard or move

the mouse to activate the monitor and

restore the image on the screen.

You may get a blank screen if you

boot the system before you connect

the DVI cable, or disconnect and then

reconnect the DVI cable while the

system is running as certain types of

graphic cards do not send out video

signals. Connect the DVI cable and

then reboot the system.