Samsung 2043SWX - 5ms Widescreen LCD Monitor 빠른 시작 매뉴얼 - 페이지 15

{카테고리_이름} Samsung 2043SWX - 5ms Widescreen LCD Monitor에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung 2043SWX - 5ms Widescreen LCD Monitor 26 페이지. Quick guide (korean)
Samsung 2043SWX - 5ms Widescreen LCD Monitor에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (23 페이지), (빠른 시작 가이드 (24 페이지), (한국어) 빠른 시작 매뉴얼 (22 페이지)

페이지 인쇄

900 60 Hz" message comes up, disconnect the cable from the computer while the monitor is

still powered on.

If there is a message coming up on the screen or if the screen goes white, this means the

monitor is in working condition.

In this case, check the computer for trouble.

{2043SW/2043SWX} Check List

Note

Before calling for assistance, check the information in this section to see if you can remedy

any problems yourself. If you do need assistance, please call the phone number on the In-

formation section or contact your dealer.

No images on the screen. I cannot turn on the monitor.

Is the power cord connected properly?

Check the power cord connection and supply.

Can you see "Check Signal Cable" on the screen?

(Connected using the D-sub cable)

Check the signal cable connection.

(Connected using the DVI cable)

If you still see an error message on the screen when the monitor is connected properly,

check to see if the monitor status is set to analog.

If you still see an (error) message on the screen when the monitor is connected properly,

check to see if the monitor status is set to analog. Press '

the monitor double-check the input signal source.

If the power is on, reboot the computer to see the initial screen (the login screen), which

can be seen.

If the initial screen (the login screen) appears, boot the computer in the applicable mode

(the safe mode for Windows ME/XP/2000) and then change the frequency of the video

card.

(Refer to the Preset Timing Modes)

If the initial screen (the login screen) does not appear, contact the Service Center or

your dealer.

Can you see "Not Optimum Mode", "Recommended Mode 1600 x 900 60 Hz" on the

screen?

You can see this message when the signal from the video card exceeds the maximum

resolution and frequency that the monitor can handle properly.

Adjust the maximum resolution and frequency that the monitor can handle properly.

If the display exceeds SXGA or 75 Hz, a "Not Optimum Mode", "Recommended

Mode 1600 x 900 60 Hz" message is displayed. If the display exceeds 85 Hz, the display

will work properly but the "Not Optimum Mode", "Recommended Mode 1600 x 900 60

Hz" message appears for one minute and then disappears.

Please change to the recommended mode during this one-minute period.

(The message is displayed again if the system is rebooted.)

There is no image on the screen. Is the power indicator on the monitor blinking at 1

second intervals?

Troubleshooting

/SOURCE' button to have