C
onnect the projector
to your notebook
Before using the projector, make sure you read the safety instructions in
the User's Guide on your projector CD.
1
Locate the required cables:
Power cord
VGA computer cable
2
Connect the computer cable to
the blue Computer (Component Video)
port on the projector.
3
Connect the other end to your notebook's
video-out or
monitor port.
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.
T
urn on your equipment
1
Turn on your notebook.
2
Open the A/V Mute slide (lens cover).
NOTE:
The slide must be
opened completely.
3
Make sure the Power light
is orange and not flashing.
4
Press the
Power button
to turn on the projector.
The projector beeps once,
and the Power light flashes
green and then stays on.
To shut down the projector, press the
simply unplug it. You don't have to wait for the projector to cool off.
*411482100*
*411482100*
Power light
Power button
Power button twice and
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User's Guide.
A
djust the image
1
If you've turned on your notebook and switched it to external display,
but you don't see an image, press the Source Search button on the
projector or the Search button on the remote control to select the
image source.
NOTE:
If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
To raise the image, press
the foot release button
for the front adjustable
foot and lift the front.
Release the button to
lock the foot in position.
3
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or
enlarge the image.
Focus
Zoom
4
If your image looks like
or
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
If your image looks like
or
on the projector to correct it.
Turn over
PowerLite
1720/1730W
®
Quick Setup
, you've placed the projector off
, press the
or
button
페이지 인쇄