Samsung 65" 650TS Interactive Whiteboard LCD 빠른 시작 매뉴얼 - 페이지 25

{카테고리_이름} Samsung 65" 650TS Interactive Whiteboard LCD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung 65" 650TS Interactive Whiteboard LCD 30 페이지. Samsung lcd display quick start guide
Samsung 65" 650TS Interactive Whiteboard LCD에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (30 페이지)

페이지 인쇄

2) Maintaining the Flat Panel Display Screen.

Clean with a soft cloth (cotton flannel).

Symptoms and Recommended Actions

Note

A LCD Display recreates visual signals received from the computer. Therefore, if there is a

problem with the computer or the video card, this can cause the LCD Display to become

blank, have poor coloring, become noisy, etc. In this case, first check the source of the prob-

lem, and then contact a Service Center or your dealer.

Check if the power cord and the video cables are properly connected to the computer.

Check if the computer beeps more than 3 times when booting.

(If it does, request service.)

If you installed a new video card or if you assembled the PC, check if you installed the

Adaptor(video).

Check if the scanning ratio of the video screen is set to between 56 Hz ~ 85 Hz.

(Do not exceed 60Hz when using the maximum resolution.)

If you have problems in installing the Adaptor (video) driver, boot the computer in Safe

Mode, remove the Display Adaptor in the "Control Panel −> System −> Device Admin-

istrator" and then reboot the computer to reinstall the Adaptor (video) driver.

Check List

Note

•

The following table lists possible problems and their solutions. Before calling for assis-

tance, check the information in this section to see if you can remedy any problems for

yourself. If you do need assistance, please call the phone number on the Information

section or contact your dealer.

Problems related to the Installation (PC Mode)

Note

Problems related to the LCD Display installation and their solutions are listed.

The LCD Display screen flickers.

Troubleshooting

•

Do not use benzene, thinner or other flammable sub-

stances.

•

Never use acetone, benzene or thinner.

(They may cause flaws or deformation of the screen

surface.)

•

The user is responsible for any damage caused by

using these substances.