Samsung 690 Series 설치 매뉴얼 - 페이지 27

{카테고리_이름} Samsung 690 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Samsung 690 Series 48 페이지. Series 6
Samsung 690 Series에 대해서도 마찬가지입니다: 사양 (36 페이지), 사용자 설명서 (40 페이지), 설치 매뉴얼 (50 페이지)

페이지 인쇄

y The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10

seconds. All LEDs blink 5 times to acknowledge that this has been finished.

y The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The

LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the

guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.

y After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and

the RJP.

y The following table shows the approximate time in seconds to switch from the TV to the input source, based on the priority.

✎ Scenario 1: When no inputs are connected.

Source

HDMI

✎ Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.

Source

HDMI

✎ E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is viewed as the highest priority. If the RJP is

in HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5

seconds.

y To connect audio (Ipod or Mp3), Music mode should be ON.

y A/V, PC and HDMI input sources are supported.

To Connect

2 Sec

0.7 Sec

3.9 Sec

Disconnect

To Connect

4.5 Sec

0.7 Sec

3.9 Sec

Total

2 Sec

6.5 Sec

1.4 Sec

7.8 Sec

English