Siemens SQM53.464R1Z3 기술 지침 - 페이지 23
{카테고리_이름} Siemens SQM53.464R1Z3에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SQM53.464R1Z3 31 페이지. Reversing
Siemens SQM53.464R1Z3에 대해서도 마찬가지입니다: 기술 지침 (31 페이지), 기술 지침 (31 페이지)
페이지 인쇄
SQM5... Reversing Actuators
AGA56.9A...
Circuit Board
Installation, Continued
Siemens Building Technologies, Inc.
4. Guide the base circuit board from the
switch housing side of the actuator into
the bottom of the circuit board mounting
bracket. See Figure 23.
5. Re-install the actuator motor capacitor.
See Figure 24.
6. Gently guide the terminal board into the
support slots and slide the terminal
board downward until both supports
snap into place. See Figure 25.
7. See Figure 26 and make the following
connections to the actuator:
a. Connect the wire, marked "1" from
the circuit board to switch I,
terminal 1.
b. Connect the wire, marked "2" from
the circuit board to switch II,
terminal 2. Connect the white wire,
marked "3" from the circuit board to
switch III, terminal 3.
c. Connect the wire, marked "13" from
the circuit board to switch III,
terminal 13.
d. Connect the neutral wire, marked
"N" to the double terminal block
located on the outer end of the
switch housing.
e. Connect the grounding wire marked
"51" to the ground terminal located
to the right of the auto/manual
switch.
Technical Instructions
Document No. 155-517P25
Jan 25, 2022
Figure 23.
Figure 24.
Figure 25.
Page 23