Cisco 3600 Series 구성 참고 사항 - 페이지 13

{카테고리_이름} Cisco 3600 Series에 대한 구성 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3600 Series 18 페이지. Memory upgrade
Cisco 3600 Series에 대해서도 마찬가지입니다: 제품 개요 (10 페이지), 업그레이드 지침 (30 페이지), 소유자 매뉴얼 (17 페이지), 애플리케이션 노트 (41 페이지), 구성 매뉴얼 (36 페이지), 사용자 설명서 (25 페이지), 부록 (15 페이지), 사용자 설명서 (7 페이지), 매뉴얼 (5 페이지), 구성 참고 사항 (23 페이지), 구성 참고 사항 (25 페이지)

Wall-Mounting the Cisco 3620 Router

This section explains how to wall-mount the Cisco 3620 router.

Attaching Wall-Mounting Brackets to the Cisco 3620 Router

To install the router on a wall, ﬁrst attach the brackets on each side of the chassis as shown in

Figure 24, using the special plastic washers and slotted hex-head screws. Place the washers so that

the narrow shoulder faces the router chassis.

Note

router. All other rack- and wall-mount brackets are attached to the router using Phillips-head screws,

without washers.

Figure 24

ACTI VE

READ Y

Mounting the Cisco 3620 Router on the Wall

After fastening the brackets to the chassis, follow this procedure to mount it on the wall (refer to

Figure 25):

Step 1

Step 2

Caution

Step 3

The hex-head screws and plastic washers are used only for wall-mounting the Cisco 3620

Cisco 3620 Wall-Mount Bracket Attachment

PCM CIA

Note: The second bracket attaches to the other side of the chassis.

Using the brackets as a pattern, mark and drill holes on the board where you will fasten

the router. Do not attach the router to the board yet.

Locate the wall studs where you plan to attach the router.

The router must be fastened securely to two studs.

Drill wall-mount screw locations through the plywood board and studs.

Plan to mount the router so that the front and rear of the chassis are perpendicular

Note

to the ﬂoor, with the front upward and at eye level, so you can read the LEDs.

Cisco 3600 Series Rack-Mount and Wall-Mount Configuration Note

Wall-Mounting the Router