Siemens SSC31 매뉴얼 - 페이지 5
{카테고리_이름} Siemens SSC31에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SSC31 9 페이지. Electromotoric actuators
Siemens SSC31에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지)
페이지 인쇄
Maintenance
Repair
Disposal
Warranty
Technical data
Power supply
Control
Functional data
Electrical connections
Industry standards
Siemens Building Technologies
HVAC Products
When servicing the actuator:
•
Switch off power
•
If necessary, disconnect the terminals
•
The actuator must only be commissioned with a correctly mounted valve in place!
The SSC... actuators cannot be repaired. They must be replaced as a complete unit.
The device may not be disposed of together with domestic waste. This applies in
particular to the PCB.
Legislation may demand special handling of certain components, or it may be sensible
from an ecological point of view.
Current local legislation must be observed.
∆
The technical data (
p
specific applications are valid only in conjunction with the Siemens valves listed in this
Data Sheet under «Equipment combinations».
The use of the SSC... actuators in conjunction with third-party valves invalidates
any warranty offered by Siemens Building Technologies / HVAC Products.
Rated voltage
Voltage tolerance
Rated frequency
Max. power consumption
Fuse for incoming cable (fast)
Control signal
Input impedance for DC 0...10 V
Positioning accuracy for DC 0...10 V
Parallel operation
3)
(number of actuators)
Running time for 5.5 mm stroke
Capacitor charging time
Fail-safe run time
Nominal stroke
Nominal force
Permissible temperature of
medium in the connected valve
Terminal block
, pluggable
Terminal block color
Cable strain relief
Meets the requirements for CE
marking:
EMC directive
Low-voltage directive
2)
UL approval
2)
CUL approval
Safety class
Housing protection standard
Electrical Actuators
∆
,
p
, leakage rates, noise levels, service life, etc.) relating to
max
s
SSC31
AC 230 V
± 15 %
6 VA
3-position
–––
–––
150 s ± 2 %
green
89/336/EEC
73/23/EEC
UL873-listed
certified to Canadian Standard C22.2 No. 24-93
II
SSC81
SSC61
AC 24 V
AC 24 V or DC 24 V
± 20 %
± 20 %
50 / 60 Hz
0.8 VA
2 VA
2 A
DC 0...10 V
> 100 kOhm
< 2 % of nominal stroke
max. 10
30 s ± 10 %
–––
–––
5.5 mm
> 300 N
1...110 °C
screw terminals for max. 3 mm
grey
red
for cables 4...11 mm dia.
emissions
EN 50081-1
immunity
EN 61000-6-2
EN 60730-1
III
IP40 to EN 60529
SSC61.5
± 25 %
1)
2 VA
max. 180 s
30 s
2
red
5/8
CA1N4895en
08.03.2004