Cisco 522 사용자 설명서 - 페이지 12
{카테고리_이름} Cisco 522에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 522 46 페이지. Ip phones with multiplatform firmware
Cisco 522에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지), 관리 매뉴얼 (48 페이지), 설치 매뉴얼 (39 페이지), 매뉴얼 (24 페이지)
페이지 인쇄
Cisco Headset 560 Series Standard Base
The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 6: Cisco Headset 561 and 562 Buttons
Number
Button
1
2
3
4
N/A
Cisco Headset 560 Series Standard Base
The standard base charges your headset and has LEDs that shows your headset's battery level and call state.
You can also answer and end calls when you lift or place your headset on the base.
Cisco Headset 500 Series User Guide
6
Name
Description
Power and Call button
Use to power the headset on and off.
Press and hold for 4 seconds to power the headset off and on.
Incoming and active call management depends upon if you have one
call or multiple calls.
One call:
Multiple calls:
Mute button
Toggle the microphone on and off.
Volume buttons
Adjust the volume on your headset.
LED
Shows the headset status:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve a
call from hold.
• Press twice to reject an incoming call.
• Press and hold to end a call.
• Press once to put an active call on hold, and to answer a second
incoming call.
• Press once to put a call on hold. Press again to resume a call, or
press and hold until you hear a tone to end the current call and
to resume a held call.
• Press and hold until you hear a tone to end an active call, and to
answer another incoming call.
• Press twice to stay on a current call, and to reject a second
incoming call.
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in process or the headset
is pairing with the base station.
Your Headset