Cisco 6800 Series 유지 관리 매뉴얼 - 페이지 2

{카테고리_이름} Cisco 6800 Series에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 8 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 하드웨어 설치 (20 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Cisco 6800 Series 유지 관리 매뉴얼
Perform a Factory Reset with the Phone Keypad
Note
When an administrator has set up emergency calls, the phone requests an updated location whenever the
administrator does the following actions:
• Registers the phone with the call server.
• Restarts the phone (phone is registered).
• Changes the network interface that is used for the SIP registration.
• Changes the IP address of the phone.
Perform a Factory Reset with the Phone Keypad
Use these steps to reset the phone to factory default settings using the phone keypad.
Procedure
Step 1
Unplug the phone:
• If using PoE, unplug the LAN cable.
• If using the power cube, unplug the power cube.
Step 2
Wait 5 seconds.
Step 3
Press and hold # and plug the phone back in.
When the phone boots up:
• For Cisco IP Phone 6821 Multiplatform Phones, the lights on the light strip and the line keys light up.
• For Cisco IP Phone 6841 and 6851 Multiplatform Phones, the lights on the headset button, the speaker
Step 4
Press the 123456789*0# keys in sequence.
For Cisco IP Phone 6821 Multiplatform Phones, when you press a key, the lights on the line keys and the
light strip flash.
For Cisco IP Phone 6841 and 6851 Multiplatform Phones, when you press 1, the handset light and the light
on the speaker button turn off.
After you press these buttons, the phone goes through the factory reset process.
If you press the buttons out of sequence, the phone powers on normally.
Caution
Do not power down the phone until it completes the factory reset process, and the main screen appears.
Maintenance
2
button, and the handset flash.
Maintenance