Cisco 6800 Series 하드웨어 설치 - 페이지 19

{카테고리_이름} Cisco 6800 Series에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 20 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 유지 관리 매뉴얼 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Hardware Installation

Set Up the Charging Cradle

You use the charging cradle to charge the handset. The cradle has a built-in USB cable that plugs into the

power adapter. The power adapter is designed for your country's electrical outlet configuration and power

rating.

The charging cradle with 6825 Handset and 6825 Ruggedized Handset has a USB port on the side of the

cradle and an LED indicator in the front of the cradle. The side USB port doesn't have supported use at this

time. The LED indicator is lit when the handset is charging.

The charging cradle shipped with 6823 Handset doesn't have the USB port and the LED indicator. You can

also use the charging cradle of 6825 Handset to charge this handset.

Procedure

Step 1

Place the cradle on a level surface.

Step 2

Plug the USB connector of the power cord into the power adapter.

Step 3

Plug the power adapter into the electrical outlet.

Figure 5: 6825 Handset and 6823 Handset Charging Cradle

You use the handset charger to charge the handset battery.

Note

The battery comes partially charged, but you should charge it for a minimum of 10 hours before you use it for

the first time. If you don't fully charge it, you may decrease the life of the battery.

If you remove and replace the battery from the handset, you need to fully discharge and then fully charge the

battery so that the battery indicator is accurate.

Set Up the Charging Cradle

Hardware Installation