Cisco 6900 Series 참조 매뉴얼 - 페이지 2
{카테고리_이름} Cisco 6900 Series에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6900 Series 4 페이지. 6900 series unified ip phone
Cisco 6900 Series에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 릴리스 정보 (18 페이지), 빠른 참조 매뉴얼 (4 페이지)
페이지 인쇄
Reference Guide for the Cisco 6900 Series Phones
How To
INTERNAL CALL
Lift handset, Dial Phone Number
(On-Net)
Lift handset, Dial Phone Number.
EXTERNAL CALL
Local calls: Dial Phone Number
(Off-Net)
Long distance: 1 + Area Code + 7-digits
Use One of the Following Methods:
A. Lift the Handset, and dial a number.
B. Press the "Speaker" button, and dial number.
C. While on an active call, a 2
Place a Call
press the "Hold" Button to hold 1
"New Call" Soft Key, hear dial-tone, dial number.
D. Pre-dialing: With handset in cradle, use the dial-
pad to dial digits, press the "Call" Soft Key to dial.
The display is dynamic and changes according to the
phone state. Available features appear across the
Soft Keys
bottom of your display (Soft Key Labels). To use these
features, press the corresponding Soft Key Button
located directly below the desired feature.
Navigation Bar scrolls through menus by pressing up or
Navigation Bar
down arrows.
(with Select
When handset is on-hook: Press UP Arrow to display
Button)
phone numbers from your Placed Call Log, or press the
DOWN Arrow to view Speed Dial List.
To Hold: While connected, press the "Hold" Button.
Hold
and
To Resume: Press the "Resume" Soft Key, or the
Resume
Blinking Line Button to return to the call.
While on a call, a call waiting tone (single beep) is
heard, the display will briefly provide call information
nd
of 2
Call Waiting
To Answer 2
Including Cisco Models: 6921, 6941, and 6961
Directions
Note display icon indicating the call is on Hold (paused).
incoming caller and the line button will flash.
nd
Call or Toggle between calls:
Press the Blinking Line button.
st
(1
call is automatically put on hold)
Page 2 of 4
*
(See Notes)
*
(See Notes)
nd
call may be made,
st
call. Press the
Notes
* Pending Location: 7 or 10
Digits may be required – See
your System Administrator.
NO Access Code Required.
* Pending Location: 7 or 10
Digits may be required – See
your System Administrator.
To Correct a Dialing Error:
Press the backspace " <X "
Soft Key to erase previous
digit(s), and then enter the
correct digit(s).
To view additional features
press the "More" Soft Key.
Use center "Select" button
to choose the highlighted
display item.
More than one call on
Hold: Use the Navigation
Bar to Highlight the call
then press Resume.
To End a call: While
connected (highlighted in
display), press the "End"
Soft Key or hang-up.