Cisco 6901 Standard 매뉴얼 - 페이지 24

{카테고리_이름} Cisco 6901 Standard에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6901 Standard 28 페이지. Unified ip phone
Cisco 6901 Standard에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 관리 매뉴얼 (10 페이지), 사용자 설명서 (15 페이지), 관리 매뉴얼 (12 페이지), 사용자 설명서 (50 페이지), 매뉴얼 (10 페이지)

페이지 인쇄

Cisco Unified IP Phone Deployment

When deploying a new IP telephony system, system administrators and network administrators must complete

several initial configuration tasks to prepare the network for IP telephony service. For information and a

checklist for setting up and configuring a Cisco IP telephony network, see the "System Configuration Overview

"chapter in Cisco Unified Communications Manager System Guide.

After you set up the IP telephony system and configure system-wide features in Cisco Unified Communications

Manager, you can add IP Phones to the system.

Cisco Unified IP Phones Setup in Cisco Unified Communications Manager

To add phones to the Cisco Unified Communications Manager database, you can use:

• Autoregistration: Not supported if Cisco Unified Communications Manager operates in mixed mode.

• Cisco Unified Communications Manager

• Bulk Administration Tool (BAT)

• BAT and the Tool for Auto-Registered Phones Support (TAPS)

For general information about configuring phones in Cisco Unified Communications Manager, refer to the

following documentation:

• "Cisco Unified IP Phones", Cisco Unified Communications Manager System Guide

• "Cisco Unified IP Phone Configuration", Cisco Unified Communications Manager Administration Guide

• "Autoregistration Configuration", Cisco Unified Communications Manager Administration Guide

The following section provides additional information.

Set Up Cisco Unified IP Phone 6901 and 6911 in Cisco Unified Communications Manager

The following procedure provides an overview of configuration tasks for the Cisco Unified IP Phone 6901

and 6911 in Cisco Unified Communications Manager Administration. The procedure presents a suggested

order to guide you through the phone configuration process. Some tasks are optional, depending on your

system and user needs. For detailed procedures and information, see the sources in the procedure.

Procedure

Step 1

Gather the following information about the phone:

• Phone Model

Cisco Unified IP Phone

• Enabled: If you are using a switch that supports multi-domain authentication, you can continue to

use the Voice VLAN.

• Disabled: If the switch does not support multi-domain authentication, disable the Voice VLAN and

consider assigning the port to the native VLAN.

Cisco Unified IP Phone