Cisco 6941 - Unified IP Phone Slimline VoIP 사용자 설명서 - 페이지 18

{카테고리_이름} Cisco 6941 - Unified IP Phone Slimline VoIP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6941 - Unified IP Phone Slimline VoIP 24 페이지. Two-line ip endpoint supporting both video and light-to-moderate voice communications
Cisco 6941 - Unified IP Phone Slimline VoIP에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 릴리스 정보 (18 페이지), 데이터시트 (5 페이지), 사용자 설명서 (38 페이지), 관리 매뉴얼 (14 페이지), 설정 매뉴얼 (16 페이지), 특징 (29 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 참조 매뉴얼 (4 페이지), 빠른 참조 카드 (2 페이지), 관리 매뉴얼 (19 페이지), 사용 설명서 (7 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)

3. Wait for the call to be answered. Speak to the transfer recipient. Then press the Transfer button or hang up the handset.

4. If the transfer fails, press the Resume soft key to return to the original call.

Cancel Transfer

1. To cancel your consult call-transfer attempt:

Press the Cancel soft key.

–

Note

In the Cisco Unified Communications Manager Express mode, Cisco IP phone models 6921 and 6941 only supports

one call per button. It is recommend to configure the Cisco IP phone models 6921 and 6941 dn as dual-line dn and the

huntstop channel under the dn. The second channel on the dn can only be used for call transfer or conference.

Establish a Conference Call

To create a three-party conference call:

1. During a call, press the Conference button to open a new line and put the first party on hold.

2. Place a call to another number.

3. Press Conference button again to add the new party to the call.

To establish a conference call between two- and three-party calls to a Cisco Unified IP phone, one active and the other on hold:

• Press the Conference button on the Cisco Unified IP phone.

Your system administrator must have configured the system for three-party or eight-party ad-hoc conferences.

Note

To end the conference call:

• Hang up the handset, or press the Cancel soft key.

Note

Depending on the configuration when the conference call initiator disconnects, the conference call terminates.

Alternate Methods to End a Conference Call

Call initiators can one of the following methods (functionality will vary according to your system configuration):

• To end the conference and remain connected to the most recent call, press the Conference button. The older call is placed

on hold.

• To disconnect from the conference, hang up the handset. The other parties remain on the conference call.

Call park allows a user to place a call on hold at a designated parking slot from which the call can be retrieved by anyone on

the system.

Contact your system administrator for your call park slot number.

Note

To park a call and retrieve a call:

1. During a call, press the Park soft key, then hang up.

For the duration of the call, your phone displays the call park number where the system stored the call.

2. Retrieve the call from any other Cisco Unified IP Phone in your network by entering the call park number.