Cisco 6961 - Unified IP Phone Standard VoIP 관리 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 6961 - Unified IP Phone Standard VoIP에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6961 - Unified IP Phone Standard VoIP 19 페이지. Unified communications manager express
Cisco 6961 - Unified IP Phone Standard VoIP에 대해서도 마찬가지입니다: 데이터시트 (5 페이지), 릴리스 정보 (18 페이지), 데이터시트 (5 페이지), 사용자 설명서 (38 페이지), 관리 매뉴얼 (14 페이지), 설정 매뉴얼 (16 페이지), 특징 (29 페이지), 참조 매뉴얼 (4 페이지), 사용 설명서 (6 페이지), 빠른 참조 카드 (2 페이지), 빠른 참조 매뉴얼 (2 페이지)

페이지 인쇄
Cisco 6961 - Unified IP Phone Standard VoIP 관리 매뉴얼

Set Domain Name Field

Option
PC Port Setup
LLDP-MED: Switch
Port
Set Domain Name Field
Procedure
Step 1
Set the DHCP Enabled option to No.
Step 2
Scroll to the Domain Name option, press Edit, and then enter a new domain name.
Step 3
Press Apply, and then press Save.
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications
Manager 10.0 (SCCP and SIP)
6
Description
Speed and duplex of the access port. Valid
values:
• Auto Negotiate
• 1000 Full: 1000-BaseT/full duplex
(Supported only for Cisco Unified IP
Phone 6945.)
• 100 Half: 100-BaseT/half duplex
• 100 Full: 100-BaseT/full duplex
• 10 Half: 10-BaseT/half duplex
• 10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you
must change the SW Port Configuration
option to the same setting.
Enables and disables Link Layer Discovery
Protocol Media Endpoint Discovery
(LLDP-MED) on the switch port. Use this
setting to force the phone to use a specific
discovery protocol, which should match the
protocol supported by the switch. Settings
include:
• Enabled: default
• Disabled
Cisco Unified IP Phone Settings
To Change
Set PC Port Configuration Field,
on page 8
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.