Cisco 7811 펌웨어 마이그레이션 마스터 매뉴얼 - 페이지 15

{카테고리_이름} Cisco 7811에 대한 펌웨어 마이그레이션 마스터 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7811 31 페이지. Mpp phones
Cisco 7811에 대해서도 마찬가지입니다: 매뉴얼 (27 페이지), 시작하기 (6 페이지), 설치 매뉴얼 (39 페이지), 매뉴얼 (20 페이지), 재구성 매뉴얼 (2 페이지), 시작하기 (2 페이지), 빠른 참조 카드 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

After reboot, you will be on the transitional load. You will see "Configuration check in progress" and you may see a warning "Failed

to download configuration. Contact your administrator." Do NOT click "Retry". If you click "Retry" the phone will reboot and display

the warning message again. The warning message pertains to Bulk Provisioning. Bulk provisioning is covered in the Appendix.

10. Determine the IP Address of your phone via Settings -> Status -> Network Status -> IPv4.

11. Type the following into your web browser:

12. In your web browser, navigate to Voice -> Provisioning.

13. Scroll down to "Firmware Upgrade" and paste the following into the "Upgrade Rule":

Upgrade Rule:

http:// CUCM-ip-address:6970/sipxxxx.12-5-1SR1-4.loads

Note: This Upgrade Rule points to 12.5(1). This is an Enterprise Firmware image than can be registered to the Unified CM.

14. Scroll down to "Firmware Upgrade" and paste the following into the "Transition Load Authorization Rule".

Transition Load Authorization Rule:

Example Upgrade Rule and Transition Load Authorization Rule:

15. After saving, you should soon see the following message indicating success:

16. After successful upgrade, register the phone to CUCM using DHCP Option 150 or Alternate TFTP.

Select Settings -> Admin Settings -> Network Setup -> IPv4 Setup

Click Apply.

Validate that the phone has registered to Unified CM.

MPP to Enterprise firmware conversion is now complete!

http://ip_address_of_phone/admin/advanced

http:// CUCM-ip-address:6970/$MAU_M2E.lic

• Alternate TFTP: Yes

• TFTP Server 1: CUCM-IP-address

where sipxxx is the firmware filename on the Unified CM.

Page 15 of 30