Digital Home System DHS-ZW-SNMT-01 사용자 설명서 - 페이지 4

{카테고리_이름} Digital Home System DHS-ZW-SNMT-01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Home System DHS-ZW-SNMT-01 14 페이지. Z-wave motion sensor

Include or exclude mode

1. Make sure your Z-Wave controller is in the right operation mode (include or exclude).

2. When the Z-Wave Motion Sensor is mounted, remove it from the back cover as explained

in step one of the Mounting instructions.

3. Press and hold the tamper for 4 seconds (indication mode: Ready for learn mode). Now

release the tamper switch to start the inclusion or exclusion process (indication mode: Learn

in progress).

Indication mode

The indicator light gives various statuses of the device as follows:

1. Ready for learn mode:

2. Learn in progress (add):

3. Learn in progress (remove):

4. Learn mode success:

5. Learn mode failed:

6. Tamper pressed/released:

7. Mounting successful:

indicator light blinks every second

indicator light 2 times every second.

indicator light 3 times every second.

indicator light is on for one second.

indicator light blinks 8 times rapidly.

indicator light blinks 3 times rapidly.

indicator light is on for 1 second.

Integration with Vera Home Controller

MiCasaVerde Vera2/3/Lite (refered later as Vera - some minor di erences in User Interface

UI4 and UI5 explained) is a fully featured, easy to install, con gure and use Home Automa-

tion controller with Z-Wave build-in interface.

More information about Vera is available at: http://wiki.micasaverde.com or

http://forum.micasaverde.com or http://www.zwave.com.au

Australian version of Vera Home Controller (921.42MHz build-in Z-Wave interface) is avail-

able at http://www.zwave.com.au

Vera 2/3/Lite needs to work with Z-Wave interface in version 3.20. Please check the follow-

ing options in your Vera2 Dashboard under "Z-Wave Device / Options" or Vera3 under "Z-

Wave Settings". Polling setting are just an example here and can be set up as you need.

If your settings are di erent, then change them as per above screenshot or follow the in-

structions on http://wiki.micasaverde.com to setup Z-Wave interface to version 3.20.