Digital Home System DHS-ZW-SNMT-01 사용자 설명서 - 페이지 8

{카테고리_이름} Digital Home System DHS-ZW-SNMT-01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Home System DHS-ZW-SNMT-01 14 페이지. Z-wave motion sensor

3. Click SAVE in Vera and wait till new settings are saved in Vera.

Your Temperature Sensor is set up.

You may want to change its name or assign it to room.

Con guring the Illumination Sensor

NOTE:

There are no con gurable parameters related to the

You have to change the UPnP les to enable proper integration and presentation of

the Illumination Sensor in Vera. The preinstalled UPnP device for your Illumination

Sensor is "LightSensor".

1. Open settings box for "_GenericIO" with

tions" tab.

2. Replace the content of the following two elds with the values provided below:

Illumination Sensor.

altid=e2

in Vera dashboard. Go to "Device Op-

device_type = urn:schemas-micasaverde-com:device:LightSensor:1

device_ le = D_LightSensor1.xml

3. Click SAVE in Vera and wait till new settings are saved in Vera.

4. Press the temper button on the device and keep it for 3-7 seconds, then release. This is to

wake up and propagate the settings.

Your Illumination Sensor is set up.

You may want to change its name or assign it to room.

By now, all your three sensor should be set up in Vera and you should see the following

three logical devices in the Vera dashboard (See below picture).

If you still see old "_GenericIO" devices (so in total more then three) that means Vera

didn't refreshed your dashboard yet. Try to refresh it manually by clicking on the refresh

button (see below in red)

You can test or re-con gure the sensor, by setting up scenes with motion sensor as an

event and by changing the timeout settings as per above steps.