Siemens XC1001-A 운영 - 페이지 9

{카테고리_이름} Siemens XC1001-A에 대한 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens XC1001-A 32 페이지. Extinguishing control unit

Building Technologies

Fire Safety

Assembly, installation, commissioning and maintenance

If you require tools such as a ladder, these must be safe and must be intended

for the work in hand.

When starting the fire control panel ensure that unstable conditions cannot

arise.

Ensure that all points listed in the 'Testing the product operability' section below

are observed.

You may only set controls to normal function when the product operability has

been completely tested and the system has been handed over to the customer.

Testing the product operability

Prevent the remote transmission from triggering erroneously.

If testing building installations or activating devices from third-party companies,

you must collaborate with the people appointed.

Before actuating extinguishing manual release for test purposes, mechanically

block the activation of extinguishing.

The activation of fire control installations for test purposes must not cause injury

to anyone or damage to the building installations. The following instructions

must be observed:

Use the correct potential for activation; this is generally the potential of the

building installation.

Only check controls up to the interface (relay with blocking option).

Make sure that only the controls to be tested are activated.

Inform people before testing the alarming control devices and allow for possible

panic responses.

Inform people about any noise or mist which may be produced.

Before testing the remote transmission, inform the corresponding alarm and

fault signal receiving stations.

Modifications to the system layout and products

Modifications to the system and to individual products may lead to faults,

malfunctioning and safety risks. Written confirmation must be obtained from

Siemens and the corresponding safety bodies for modifications or additions.

Modules and spare parts

Components and spare parts must comply with the technical specifications

defined by Siemens. Only use products specified or recommended by Siemens.

Only use fuses with the specified fuse characteristics.

Wrong battery types and improper battery changing lead to a risk of explosion.

Only use the same battery type or an equivalent battery type recommended by

Siemens.

Batteries must be disposed of in an environmentally friendly manner. Observe

national guidelines and regulations.

Safety

A6V10257477_c_en_--

2012-06