Siemens CM676GB.1 사용자 설명서 및 설치 지침 - 페이지 27
{카테고리_이름} Siemens CM676GB.1에 대한 사용자 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens CM676GB.1 44 페이지.
페이지 인쇄Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up and "Demo
mode is switched on"
appears in the dis-
play.
The appliance does
not start and "Cook-
ing compartment too
hot" appears in the
display.
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
Cause and troubleshooting
Electronics fault
1.
Briefly disconnect the appliance from the power supply by switching off the fuse.
2.
Reset the basic settings to the factory settings.
→ "Basic settings", Page 19
There has been a power cut.
▶
Implement the settings for the initial configuration.
→ "Carrying out the initial configuration", Page 12
Malfunction
▶
Call the after-sales service.
→ "Customer Service", Page 28
Different causes are possible.
▶
Check any notifications that appear in the display.
→ "Displaying information", Page 13
Device is in demo mode.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and back on again.
2.
Switch off demo mode within three minutes in the
→ "Basic settings", Page 19.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
The cooking compartment is too hot for the selected dish or type of heating.
▶
Allow the cooking compartment to cool down and start again.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 19
The cleaning function locks the appliance door;
▶
Allow the appliance to cool down until goes out in the display.
The childproof lock locks the appliance door.
▶
Use the
button to deactivate the childproof lock.
→ "Childproof lock", Page 19
You can switch off the lock in the basic settings.
→ "Basic settings", Page 19
The drying function is switched on.
The LED light is defective.
Note: Do not remove the glass cover.
▶
Call the after-sales service.
→ "Customer Service", Page 28
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch off the appliance with
2.
Then use
to switch on the appliance and set the required operation.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
lights up in the display.
first.
Troubleshooting en
27