Registering and deleting projectors for monitoring
Procedures for registration
f
3
Select the projector(s) to be registered, and then click
[Edit].
The following window will be displayed.
Make the necessary settings while referring to the following
table.
Display name Enter the name of the projector(s) to be displayed in
"Grouping view" or "Detail list view".
Up to a maximum of 32 bytes can be entered.
A space cannot be used as the first character.
Display icon
Select the icon(s) to be displayed in "Grouping view"
or "Detail list view".
Parent group
Select when registering a projector in a group.
If no groups have been created, this cannot be
selected. s"Registering several projectors to a
monitoring group all at once"
4
Projectors that have been registered using automatic search are
searched for again by projector name each time EMP Monitor is
started.
p.13
Projector
This shows the name that has been registered on the
name
projector.
IP address
This shows the IP address for the registered projector.
Use Serial ⇔
This cannot be selected when registering projectors
TCP/IP
using automatic search.
conversion
adaptor.
Port Number
This cannot be selected when registering projectors
using automatic search.
Monitor
If a Monitor Password has been set for the projector,
Password
be sure to enter the Monitor Password that has been
set. If the correct password is not entered at this time,
it will not be possible to monitor and control the
projector even though it is registered.
Description
You can enter some kind of memo about the projector.
The details you enter here will be displayed at the
projector properties.
Up to a maximum of 60 bytes can be entered.
Monitor
Select this when you want monitoring to start.
After entering the details, click [Register] to start the
registration. When the message is displayed, click
[OK].
To continue registering other projector(s), repeat Steps 3 and 4.
TIP
9
페이지 인쇄