Siemens SIWAMAT XT 750 사용 설명서 - 페이지 36
{카테고리_이름} Siemens SIWAMAT XT 750에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIWAMAT XT 750 40 페이지.
페이지 인쇄
Fault
Foam comes out.
Motor noise
Pump noise
"Lid" button cannot be
pressed.
Vibrations during wash
and spin cycles
p
y
Repeated spinning
Programme runs for
longer than usual.
Washing result not
g
satisfactory.
i f
6
Cause
Too much detergent.
Not a fault.
Noises may be generated during the running in phase of the drive motor.
Not a fault.
Noises generated when the pump starts up or draws air are normal.
Programme not ended or " "
selected.
Transit bolts not removed
Appliance feet not secured.
Appliance standing on rollers.
Not a fault.
Unbalanced load detection system attempts to remove an imbalance by
repeatedly spinning the washing.
Not a fault.
Unbalanced load detection system
attempts to remove an imbalance
by repeatedly distributing the
washing.
Foam detection function has
implemented an additional rinse
cycle to dissolve the foam.
Soiling is greater than assumed.
Insufficient detergent dispensed.
ction
Switch off the appliance.
Mix 1 tablespoon of fabric softener
with ½ litre of water and add to dis
penser II.
Switch on the appliance again.
Reduce detergent dosing for the
next wash cycle.
When the water has been drained
and the programme has ended, the
appliance lid can be opened after
approx. 2 minutes.
Remove the transit bolts; see
installation instructions.
Secure the appliance feet.
Swivel the lever from left to right.
Wash large and small items of
washing together to reduce the
imbalance.
Adjust detergent dosing for the next
wash cycle.
Select suitable programme.
Dispense detergent according to the
manufacturer's specifications.