Cisco 7906G - Unified IP Phone VoIP 사용 지침
{카테고리_이름} Cisco 7906G - Unified IP Phone VoIP에 대한 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7906G - Unified IP Phone VoIP 4 페이지. Using a handset, headset, and speaker
Cisco 7906G - Unified IP Phone VoIP에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지), 사용자 설명서 (25 페이지), 데이터시트 (6 페이지), 빠른 참조 (2 페이지)
페이지 인쇄
Using a Handset, Headset, and Speaker
The Cisco Unified IP Phone 7906G and 7911G provide a speaker for hands-free listening. When you
use the speaker, you can hear the conversation but cannot talk because the phone does not contain a
built-in microphone. To talk on a call, you must use the handset.
You can use the speaker in one of two ways, depending on how your system administrator enables the
phone. Your phone may be enabled for one of the following features, but not both at the same time:
• Group Listen
• Monitor (default)
Using the Group Listen Feature
The following table shows how you can use the Group Listen feature.
If you want to...
Use the handset
Talk using the handset and listen
on the speaker at the same time
(Group Listen)
Turn off Group Listen and use the
handset
Hang up after using Group Listen Press EndCall or hang up.
Adjust the volume level for a call
Cisco Unified IP Phone 7906G and 7911G User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 1
Then...
Lift it to go off-hook; replace it to go on-hook.
Press GListen.
Note
Group Listen must be enabled by your system administrator
for the GListen softkey to display.
Press GLOff.
Note
When using Group Listen, adjusting the volume only
changes the volume for the speaker and not the handset.
Press the up or down Volume button during a call or after
invoking a dial tone.
Press Save to preserve the volume level for future calls.
Using a Handset, Headset, and Speaker